Panasonic Toughbook CF-19KHRAG2M Reference Manual page 11

Digitizer
<Only for model with digitizer>
You can use the digitizer function to perform the same operation as the touch pad and mouse. Touch the screen surface with
the pen (included).
For further information, click
To right-click
Press and hold the button (A) of the pen, and then tap the object.
A
NOTE
The digitizer function does not work in the Setup Utility.
Operation of the digitizer
Do not apply too much pressure when operating the digitizer
Only a light touch is required to operate the digitizer. Applying too much pressure may damage the surface.
Maintaining the performance of the digitizer
When the screen becomes dirty, wipe it with an approved soft cloth
The screen is specially treated to prevent dirt from adhering to the surface, so dirt can be removed easily using a dry cloth
(use only the approved soft cloth). If the dirt does not come off easily, breathe on the surface and try again.
Do not apply water or solvents to the soft cloth.
Wash the soft cloth when it becomes dirty
When the soft cloth becomes dirty, wash it with mild detergent. Do not use bleach or fabric conditioner (softener), or try to
sterilize the cloth by boiling.
If the soft cloth is dirty, it may be ineffective in cleaning the screen, and in fact may cause dirt to adhere to the screen.
Check the following to prevent the surface of the screen from being scratched
Is the surface clean?
Is the soft cloth clean?
Is the tip of the digitizer clean?
(Start) - [All Programs] - [Tablet PC] - [Tablet PC Pen Training].
11