Table of Contents
Advertisement
in the display: e.g. 1276 hours, the
display shows the text Hr for 2
seconds, 12 (thousands and
hundreds) for 2 seconds and 76 (tens
and units).
4. To exit this mode, press any button
or switch the appliance off by means
of theOn/Off button.
If the procedure does not
work (due to timeout or
wrong keys combination),
switch the appliance off and
repeat sequence from the
beginning.
9. BEFORE FIRST USE
During installation or before
first use you may observe
some water in the appliance.
This is a residual water left
in the appliance after a full
functional test in the factory
to ensure the appliance is
delivered to customers in
perfect working order and is
no cause for concern.
1. Make sure that all transit bolts have
been removed from the appliance.
2. Make sure that the electrical power is
available and the water tap is open.
10. PROGRAMMES
10.1 Programme Chart
The programmes are described in this chart following the order of the
selector dial from the top to the bottom.
Washing programmes
Programme
MixLoad 69min
Eco 40-60
8.5 Factory Defaults
This function allows to restore the factory
default options. To activate this option
follow steps below:
1. Switch the appliance on by pressing
2. Press and hold the Stains/Prewash
3. The display will show
3. Pour 2 litres of water into the
This action activates the drain system.
4. Pour a small quantity of detergent
5. Set and start a programme for cotton
This removes all possible dirt from the
drum and the tub.
Programme description
Cotton and mixed synthetic fabrics. Ideal to wash your daily
load in a short time, for a better clothes care and good cleaning
already at 30°C.
Low energy cycle for cottons. Decreases temperature and ex‐
tends time to reach good washing results.
On/Off button.
and Time Save buttons for some
seconds.
about 5 seconds.
detergent compartment marked by
.
into the compartment marked by
at the highest temperature without
any laundry in the drum.
ENGLISH
19
for
.
Advertisement
Table of Contents
