Operation; Turning On The Scanner Power - Panasonic KV-S1045C Operating Manual

Turning on the Scanner Power

1.
Press the power switch (A) of the scanner to ON.
1
•
The LED (Green) will blink for about 30 seconds, and then it will become steady.
About LED
The status of the scanner can be established by the condition of the two LED indicators shown in the table
below:
A
Ready
B
Error
Start / Stop
A LED (Green)
ON
ON
Blink (Fast)
Blink (Slow)
Blink (Slow)
OFF
*1 It will take about 30 seconds to initialize the scanner under the following conditions:
–
Just after turning the power on
–
After about 2 hours on sleep mode
–
Over about 5 seconds with the ADF door open
B LED (Red)
OFF Ready
Blink (Slow) Caution
OFF Warming up
OFF Sleep
Blink (Slow) Caution / Sleep
ON Error
Status
*1

Operation

Operating Manual 13