Preparing The Environment; Installing Software On The Host Computer - National Instruments PXIe-7822 Getting Started Manual

1. Hardware
2. NI-RIO Media
3. Getting Started Guide

Preparing the Environment

Ensure that the environment in which you are using the NI PXIe-7822R meets the following
specifications.
............................................................................ Operating temperature
(IEC 60068-2-1, IEC 60068-2-2)
Operating humidity ............................................................................
(IEC 60068-2-56)
............................................................................ Pollution degree
Maximum altitude ............................................................................
Indoor use only.
Note
Refer to the device datasheet on

Installing Software on the Host Computer

Before using the NI PXIe-7822R, you must install the following application software and
device drivers on the host computer.
1. LabVIEW 2014 SP1 or later
2. LabVIEW Real-Time Module 2014 SP1 or later
3. LabVIEW FPGA Module 2014 SP1 or later
4. NI-RIO Device Drivers February 2015 or later
1
LabVIEW Real Time Module is only required if the R Series board is being used on a PXIe
controller with a real-time operating system.
Figure 1. Kit Contents for the NI PXIe-7822R
1
NI PXIe-7822R Getting Started Guide | © National Instruments | 3
2
0° C to 55° C
10% RH to 90% RH, noncondensing
2
2,000 m
ni.com/manuals for complete specifications.
1
3