PICTURE menu
Remote control
See "Navigating through the menu" on page 32.
See "Main menu and Sub-menu" on page 30.
PICTURE MODE
Depending on the projection environment, you can use
these preset parameter settings to optimise image
projection. Press I H to cycle through the options.
STANDARD
Setting for a general image
DYNAMIC
Bright and sharp setting
Setting for when projecting on
BLACKBOARD
a blackboard
Reproduces the original color
*1
NATURAL
of the image
Setting for a cinema type
*2
CINEMA
movie
*1. Selectable when sill image is displayed.
*2. Selectable when moving image is displayed.
NOTE:
• It may take for a while until the image stabilized in the
selected mode.
CONTRAST
You can adjust the contrast of the projected image.
Adjust the BRIGHTNESS in advance if necessary.
Lower
BRIGHTNESS
You can adjust the brightness of the projected image.
Darker
Control panel
Higher
Brighter
COLOR
You can adjust the color saturation of the projected
image. (Available with VIDEO/S-VIDEO/YP
movie/DVI movie signals only)
Lighter
TINT
You can adjust the skin tone in the projected image.
(Available with VIDEO/S-VIDEO/YP
DVI movie signals only)
More
reddish
SHARPNESS
You can adjust the sharpness of the projected image.
Less
sharp
WHITE BALANCE RED
You can adjust the white balance more properly in red
color temperature by pressing I H. (Available with
RGB/DVI still signals only)
WHITE BALANCE GREEN
You can adjust the white balance more properly in green
color temperature by pressing I H. (Available with
RGB/DVI still signals only)
WHITE BALANCE BLUE
You can adjust the white balance more properly in blue
color temperature by pressing I H. (Available with
RGB/DVI still signals only)
P
/RGB
B
R
Darker
P
/RGB movie/
B
R
More
greenish
More
sharp
E
NGLISH - 33