Onkyo TX-RZ730 Instruction Manual page 146

7. Miscellaneous
„ 1. Tuner
Change the frequency step for the tuner.
Setting Item Default Value
AM/FM 10 kHz/0.2 MHz Select a frequency step to suit your residential
Frequency Step
(North American
models)
AM Frequency 9 kHz
Step (European,
Australian and
Asian models)
2. Remote ID
Change the remote controller ID.
Setting Item Default Value
Remote ID 1
Setting Details
area.
Select "10 kHz/0.2 MHz" or "9 kHz/0.05 MHz".
• When this setting is changed, all radio presets
are deleted.
Select a frequency step to suit your residential
area.
Select "10 kHz" or "9 kHz".
• When this setting is changed, all radio presets
are deleted.
Setting Details
If multiple ONKYO products are installed in the
same room, select the ID for the remote control
used with this unit from "1", "2" and "3" to prevent
interference between the unit and other ONKYO
products. After changing the ID on the main unit,
set the same ID on the remote controller as the
main unit with the following procedure.
While pressing and holding the MODE button,
press the following buttons for approx. 3 seconds.
• To change the remote controller ID to "1":
(The remote indicator blinks once.)
• To change the remote controller ID to "2":
(The remote indicator blinks twice.)
• To change the remote controller ID to "3":
(The remote indicator blinks three times.)
Contents Connections
≫
„ 3. Firmware Update
Change the settings for Firmware Update.
Setting Item Default Value
Update Notice Enable
Version -
Update via -
NET
Update via -
USB
• Wait for a while if "Firmware Update" cannot be selected. It can be selected when the
network function is activated.
„ 4. Initial Setup
Make the initial setup from the setup menu.
• Wait for a while if "Initial Setup" cannot be selected. It can be selected when
the network function is activated.
„ 5. Lock
Lock the Setup menu so that the settings cannot be changed.
Setting Item Default Value
Setup Parameter Unlocked
146
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
Availability of a firmware update is notified via
network.
"Enable": Notify updates
"Disable": Do not notify updates
The current firmware version is displayed.
Press ENTER to select when updating the firmware
via network.
• This setting cannot be selected if you do not
have Internet access or there is no updatable
firmware.
Press ENTER to select when updating the firmware
via USB.
• This setting cannot be selected if a USB storage
device is not connected or there is no updatable
firmware in the USB storage device.
Setting Details
Lock the Setup menu so that the settings cannot be
changed.
"Locked": The menu is locked.
"Unlocked": The menu is unlocked.
≫