Onkyo TX-RZ730 Instruction Manual page 102

be output only when it is an analog or 2ch PCM audio signal. When the AV
component is connected to this unit with an HDMI cable, digital coaxial cable
or digital optical cable, change the audio output of the AV component to the
PCM output.
• When video and audio via HDMI input are output to ZONE 2, set "1. Input/
Output Assign" - "TV Out / OSD" - "Zone2 HDMI" (
Setup menu.
• For ZONE 3 output, audio from externally connected AV components can be
output only when it is an analog audio signal.
• DSD and Dolby TrueHD audio signals cannot be output to ZONE 2/ZONE 3
when selected with the "NET" input selector.
• If ZONE 2/ZONE 3 is on, power consumption during standby will increase.
• If ZONE 2 is turned on when the Pure Audio listening mode is selected in the
main room , the mode will automatically switch to the Direct listening mode.
(European, Australian and Asian models)
To set the function to off:
Press
control mode.
p127) to "Use" on the
while the remote controller is in the ZONE
Contents Connections
≫
102
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫ ≫