Unloading The Tool - DeWalt DCN701D1 Instruction Manual

English
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button 9 and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. E
Proper Hand Position (Fig. F)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the handle
as shown in Fig. F.
Fig. F
Preparing the Tool (Fig. A)
NOTICE: NEVER spray or in
any other way apply lubricants
or cleaning solvents inside the
tool. This can seriously affect
the life and performance of
the tool.
nOTE: The battery pack is not fully charged out of the
carton. Follow instructions outlined (refer to Charging
A Battery).
1. Read the Stapler Safety Warnings section of
this manual.
2. Wear eye and ear protection.
3. Remove battery from tool.
10
4. Ensure magazine is empty of all fastners.
6
10
5. Check for smooth and proper operation of cable
alignment guide
assemblies. Do not use tool if either assembly is not
functioning properly. nEVER use a tool that has the wire
indicator restrained in the actuated position.
6. Keep tool pointed away from yourself and others.
NOTICE: Do not store tool with battery pack installed.
To prevent damage to the pack and to ensure best
battery life, store battery packs out of the tool or
charger in a cool, dry location.
9
Loading the Tool (Fig. G)

WARNING: Keep the tool pointed away from yourself
and others.

WARNING: Never load staples with the wire indicator
or trigger activated.

WARNING: Always remove battery pack before
loading or unloading staples.
10

CAUTION: Keep fingers clear of pusher latch track to
prevent injury.

WARNING: Use D
Other staples can damage the wire insulation. Which
may result in electric shock, fire and/or serious injury.
1. Depress magazine release button
magazine core and pusher
end of its travel.
2. Drop staple strips into the loading slot of the
12
magazine
correctly with the slot opening. (Refer to Staple
Specifications to determine compatible size.)
Fig. G
12
3. Keeping fingers clear of the track, close the magazine by
releasing the pusher latch. Carefully allow the latch to
slide forward and engage the staple strip.
nOTE: Do not slam magazine core assembly into
magazine or you could damage staples.

Unloading the Tool


WARNING: Always remove battery pack before
loading or unloading staples.
1. Depress magazine release button
magazine core and pusher
end of its travel.
3 , wire indicator
WALT staples only in this tool.
E
7
8 out until it reaches the
6 , making sure the staple heads align
6
8
7
8 out until it reaches the
4 and pusher 8
and slide the
7
and slide the