Table of Contents
Advertisement
NLTroubleshooting
Malfunction
"E:30 / -80"
"E:38 / -25 / -26"
"E:30 / -10" and/or
46
Cause and Troubleshooting
Detergent dosage is too high.
▶ Immediate measure: mix a tablespoon of fabric softener
with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
Reduce the amount of detergent for the next wash
▶
with the same load.
Drain pump is clogged.
→ "Clean the drum", page 40
▶
if the fault is displayed again,
→ "Clean the drain pump", page 41
▶
Inlet opening of the rubber sleeve is clogged.
→ "Clean the inlet opening in the rubber sleeve",
▶
page 44
Water pressure is low.
No solution possible.
The strainers in the water supply are clogged.
▶ Clean the strainers in the water supply.
Water tap is closed.
Open the water tap.
▶
Water supply hose is kinked or pinched.
Make sure that the water supply hose is not
▶
kinked or trapped.
Water level measuring system defective.
Remark:With the error message, the device starts a
pump-down procedure.
First wait approx. 5 minutes until the pumping procedure
1.
has finished.
To reset the error message, turn off the device.
2.
Turn the device back on.
3.
If the error message appears again, please contact
4.
the service.
→
"After-sales service", page 55
Advertisement
Table of Contents
