Log Set Installation - UltraGlow G36D Owners & Installation Manual

Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken
logs can interfere with the pilot operation.
The gas log kit (Part # 780-930) contains the following pieces:
a) 02-75 Rear Log
b) 02-55 Middle Left Log
c) 02-50 Front Left Log
d) 02-53 Center Left Log
e) 02-51 Front Bottom Log
f) 02-54 Center Right Log
g) 02-52 Middle Right Log
h) Embers
i) Vermiculite
02-55
02-75
02-50
02-53
The "02" refer numbers (i.e. 02-75) are
molded into the rear of each log.
1) Carefully remove the logs from the box and unwrap them. The logs
are fragile, handle with care - do not force into position.
2) Sprinkle the vermiculite all over the top of the base brick panel.
3) Place Log 02-75 on the rear log support pins with the fl at side to the
back.
Support Pins
4) Place Log 02-51 on the front right side of the burner. Push the back
of the log against the 2 brackets with the notch on the bottom right
side of the log fi tting into the right side of the grate.
UltraGlow G36D Zero Clearance Direct Vent Gas Fireplace
®

LOG SET INSTALLATION

902-156
902-179
02-52
02-51 02-54
02-75
Bracket
Bracket
02-51
5) Position Log 02-53 across the cutouts in Logs 02-75 and 02-51 with
the notch on the left side of the log fi tting into the 2nd grate tab.
02-53
2nd Grate Tab
02-53
INSTALLATION
02-75
02-51
Notch
Notch
02-75
02-51
Cutouts
02-51
27