Troubleshooting - JVC GR-DVL600 Instructions Manual

Digital video camera

Hide thumbs

Table of Contents

If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio,

etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery

pack, AC Power Adapter/Battery Charger, etc.) and wait a few minutes; and then re-connect it and proceed

as usual from the beginning.

SYMPTOM

1. No power is supplied.

2. "SET DATE/TIME!"

appears.

3. Recording cannot be

performed.

4. There is no picture.

5. Some functions are not

available using MENU/

BRIGHT.

6. The focus does not adjust

automatically.

7. The cassette will not load

properly.

Downloaded from:

1. •The power is not connected

•The battery is dead.

2. •The date/time is not set.

•The built-in clock battery

3. •The tape's erase protection

•The Power Switch is set to

•"TAPE END" appears.

•The cassette holder cover is

4. •The camcorder is not getting

5. •The Power Switch is set to

6. •Focus is set to the Manual

•The recording was done in a

•The lens is dirty or covered

7. •The cassette is in the wrong

•The battery's charge is low.

https://www.usersmanualguide.com/

POSSIBLE CAUSES

properly.

has run out and the

previously set date/time has

been erased.

tab is set to "SAVE".

" or "OFF".

open.

power, or some other

malfunction exists.

mode.

dark place, or the contrast

was low.

with condensation.

position.