Remote Led Diagram And Icons; General System Functions; Sending Commands; Receiving Commands - CompuSTAR Pro system User Manual

Compustar user manual car alarm compustar pro system

Hide thumbs

Table Of Contents

Table of Contents

Your remote pager will indicate the status of your vehicle while in range through a series of flashing

LEDs. The unique LED design will visually display such icons as lock/unlock status, remote start

confirmation and all the icons to show your vehicle is running, impact/shock notification and much more.

Below is a chart that shows what LEDs will blink when certain commands are sent to and from the

CompuStar.

Button

The remote transmitter functions have been predetermined and programmed from the factory. The four

button configuration allows for many functions to be performed through a series of tapping, holding and /

or multiple presses of buttons. Although CompuStar PRO remotes have numerous button functions and

capabilities, please keep in mind that the most common functions are performed in one simple step.

Sending Commands

When in range, and a command has been sent, the remote pager LEDs will illuminate and the remote

will beep. For example, to send a remote start command from the pager, hold down button

seconds. The backlight will illuminate and the remote will beep once to confirm the command has been

sent and that the remote is in range. Once the vehicle has successfully remote started, the remote will

receive a command indicating the vehicle is running.

Receiving Commands

The remote pager will receive commands indicating the status of the vehicle, confirmation of sending

commands and alarm notifications. For example, after sending the lock command, the pager will be

updated with the