Sony SRS-XB32 Help Manual page 21

Perform the pairing procedure on the BLUETOOTH device to detect the speaker.
4
When a list of detected devices appears on the display of the BLUETOOTH device, select "SRS-XB32."
*
If a passkey is required on the display of the BLUETOOTH device, enter "0000."
*
The passkey may be called a "passcode," "PIN code," "PIN number," or "password."
Make the BLUETOOTH connection from the BLUETOOTH device.
5
When the BLUETOOTH connection is established, the
If the BLUETOOTH connection is not established, repeat from step
Hint
Once the BLUETOOTH function is activated on the BLUETOOTH device which has been connected to the speaker via a
BLUETOOTH connection, the BLUETOOTH device is connected to the speaker again by just pressing the
PAIRING button.
For details on operating a BLUETOOTH device, refer to the operating instructions supplied with the BLUETOOTH device.
Note
For Apple iOS devices, the unit is compatible with iOS 10.0 or later. A BLUETOOTH connection is not available on the devices
with iOS 9.x or earlier.
The pairing mode of the speaker is released after about 5 minutes and the
when pairing information is not stored in the speaker, such as at the factory settings, the pairing mode is not released. If the
pairing mode is released before finishing the process, repeat from step
The passkey of the speaker is "0000." If a passkey besides "0000" is set on the BLUETOOTH device, pairing cannot be done with
the speaker.
Once the BLUETOOTH devices are paired, there is no need to pair them again, except in the following cases:
Pairing information has been deleted after repair, etc.
The speaker is already paired with 8 devices and another device is to be paired.
The speaker can be paired with up to 8 devices. If a new device is paired after 8 devices have already been paired, the device
that was paired earliest is replaced by the new one.
The pairing information of the speaker has been deleted from the BLUETOOTH device.
The speaker is initialized.
All pairing information will be deleted. If you initialize the speaker, it may not be able to connect your iPhone/iPod touch or
computer. In this case, erase the pairing information of the speaker on your iPhone/iPod touch or computer, and then perform
the pairing procedure again.
The speaker can be paired with multiple devices, but can only play music from one paired device at a time.
(BLUETOOTH) indicator stops flashing and stays lit.
.
(BLUETOOTH) indicator flashes slowly. However,
.
21
(power)/