Martin Audio Adorn ACS-40TS-W User Manual page 16

ADORN USER GUIDE
The bracket assembly can now be placed in the ceiling. The ends of the tile rail can be easily be re-shaped to fit onto the supporting
frame for the ceiling. These simply hook on top of the ceiling frame; they are not fixed in position. The tile can now be replaced. This will
inevitably mean lifting one side of the bracket, ensure that once the tile is back in position the frame is sitting on the ceiling frame and that
the C-Bracket is accurately lined up with the hole. If necessary, reach through the hole and loosen the fixing screws holding the C-Bracket
to the rails, make any adjustments to the position and tighten the screws.
Fitting the ceiling speakers
Once a suitable hole has been prepared the ceiling speakers can be fitted. First pull the cabling down through the hole, it is important that
there is enough slack on the cable to allow easy connection of the cables to the speaker. Connect the cable as described in the Connections
chapter. Fit a safety wire to the tab and ensure this is firmly attached to a fixing point independent of the ceiling structure.
The ceiling speakers are held in position with swivel tabs which are at right angles to the final fixing position to allow placing the speaker
in the hole, these then rotate 90° as the fixing screws are tightened to hold the speaker securely in place. Before inserting the speaker into
the ceiling, ensure that all swivel tabs are rotated so they are parallel with the edge of the bezel to allow easy insertion up into the ceiling.
The connector cover sticks out at the side of the back can , this is to keep the depth of the speaker to a minimum to ensure that the
speakers are suitable for shallow voids above ceilings.
To fit the speaker, you will need to guide the connector cover and cables into the hole first and then raise the speaker into position flush
in the hole.
ADORN USER GUIDE V1.3
16
Copyright © 2022 Martin Audio Ltd.