Advertisement
TG1311_1312_1313BX(e).book Page 20 Tuesday, September 2, 2008 10:36 AM
Useful Information
Problem
Cause/solution
Caller information is not
L You must subscribe to a Caller ID
displayed.
service. Contact your service provider/
telephone company for details.
L If your unit is connected to any
additional telephone equipment,
remove and plug the unit directly into
the wall jack.
L If you use a DSL/ADSL service, we
recommend connecting a DSL/ADSL
filter between the base unit and the
telephone line jack. Contact your DSL/
ADSL provider for details.
L Other telephone equipment may be
interfering with this unit. Disconnect the
other equipment and try again.
Caller information is slow
L Depending on your service provider/
to display.
telephone company, the unit may
display the caller's information at 2nd
ring or later.
L Move closer to the base unit.
I cannot remember the
L Change the PIN using the instructions
PIN.
on page 21.
20
Liquid damage
Problem
Cause/solution
Liquid or other form of
L Disconnect the AC adaptor and
moisture has entered the
telephone line cord from the base unit.
handset/base unit.
Remove the batteries from the handset
and leave to dry for at least 3 days.
After the handset/base unit are
completely dry, reconnect the AC
adaptor and telephone line cord. Insert
the batteries and charge fully before
use. If the unit does not work properly,
contact your nearest Panasonic service
centre.
Caution:
L To avoid permanent damage, do not use a microwave oven to speed up
the drying process.
Registering the handset to the base unit
1
{j/OK}
2
{v}/{e}: "SETTING HS" i {>}
3
{v}/{e}: "REGISTRATION" i {>}
4
{v}/{e}: "REGISTER HS" i {>}
5
Press and hold {x} on the base unit for about 5 seconds.
L If all registered handsets start ringing, press {x} to stop, then start
again from step 1.
L The rest of the procedure must be completed within 4 minutes.
6
{v}/{e}: Select a base unit number. i {>}
7
Wait until "BS PIN" is displayed. i Enter the base unit PIN (default:
"0000"). i {>}
Advertisement
