Table of Contents
Advertisement
STEP 2: Selecting the function number and setting value
1. Press the SET TEMP. (
ber. To switch between the left and right digits, press the MODE
button.
2. Press the FAN button to proceed the setting value. To return the
function number selection, press the FAN button again.
3. Press the SET TEMP. (
To switch between the left and right digits, press the MODE button.
4. Press the SLEEP button, then after you hear the beep emitted from
the indoor unit, the START/STOP button in the order to confirm the
settings.
5. Press the RESET button to cancel the function setting mode.
6. After completing the function setting, be sure to disconnect the
power supply and then reconnect it.
*1: Small
is displayed on the right of the custom code during the func-
tion setting.
CAUTION
After disconnect the power supply, wait 30 seconds or more before reconnecting it. The function
setting will not become active unless the power supply is disconnected and then reconnected.
9-1. Function settings by using remote controller
) (
) buttons to select the function num-
) (
) buttons to select the setting value.
- 19 -
Function number
*1
Setting value
*1
9. Function settings
Advertisement
Table of Contents
