Table of Contents
Advertisement
PH4G--B: Installation Instruction
CAUTION - NOTICE TO RIGGERS
PRUDENCE - AVIS AUX MANIPULATEUR
ACCESS PANELS MUST BE IN PLACE WHEN RIGGING.
PANNEAUX D'ACCES DOIT ÊTRE EN PLACE POUR MANIPULATION.
Use top skid as spreader bar. / Utiliser la palette du haut comme barre de répartition
SEE DETAIL A
VOIR DÉTAIL A
RIGGING WEIGHTS (SMALL CABINET)
24
Unit
lb
kg
Rigging
365
166
Weight
NOTE: See dimensional drawing for corner weight distribution.
Step 4 – Rig and Place Unit
Rigging and handling of this equipment can be hazardous for many
reasons due to the installation location (roofs, elevated structures, etc.).
Only trained, qualified crane operators and ground support staff should
handle and install this equipment.
When working with this equipment, observe precautions in the literature,
on tags, stickers, and labels attached to the equipment, and any other
safety precautions that might apply.
Training for operators of the lifting equipment should include, but not be
limited to, the following:
1. Application of the lifter to the load, and adjustment of the lifts to
adapt to various sizes or kinds of loads.
2. Instruction in any special operation or precaution.
3. Condition of the load as it relates to operation of the lifting kit, such
as balance, temperature, etc.
Follow all applicable safety codes. Wear safety shoes and work gloves.
Inspection
Prior to initial use, and at monthly intervals, all rigging shackles, clevis
pins, and straps should be visually inspected for any damage, evidence
of wear, structural deformation, or cracks. Particular attention should be
paid to excessive wear at hoist hooking points and load support areas.
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
MINIMUM HEIGHT: 36" (914.4 mm)
HAUTEUR MINIMUM
UNIT HEIGHT
HAUTEUR D'UNITÉ
30
Unit
lb
kg
Rigging
395
179
Weight
Fig. 5 – Rigging Weights
DUCTS
DETAIL A
VOIR DÉTAIL A
RIGGING WEIGHTS (LARGE CABINET)
36
42
lb
kg
lb
440
200
475
Materials showing any kind of wear in these areas must not be used and
should be discarded.
!
UNIT FALLING HAZARD
Failure to follow this warning could result in personal injury or death.
Never stand beneath rigged units or lift over people.
1. Leave top shipping skid on the unit for use as a spreader bar to
prevent the rigging straps from damaging the unit. If the skid is not
available, use a spreader bar of sufficient length to protect the unit
from damage.
!
PROPERTY DAMAGE HAZARD
Failure to follow this warning could result in personal injury or death.
When straps are taut, the clevis should be a minimum of 36 in. (914
mm) above the unit top cover.
6
BANDE SCELLANT DOIT ÊTRE
SEAL STRIP MUST BE IN
EN PLACE AVANT DE PLACER
PLACE BEFORE PLACING
UNIT ON ROOF CURB
L'UNITÉ SUR LA BASE DE TOIT
50CY502286 2.0
48
kg
lb
kg
215
500
227
WARNING
WARNING
A09051
60
lb
kg
515
234
Advertisement
Table of Contents
