Table of Contents
Advertisement
16
www.aeg.com
7.3 Introduction
The options/functions are
not selectable with all
washing programmes.
Check the compatibility
between options/functions
and washing programmes in
the "Programme Chart". An
option/function can exclude
another one, in this case the
appliance doesn't allow you
to set the incompatible
options/functions together.
Make sure the screen and
touch buttons are always
clean and dry.
7.4 Finish In
Set this option as last after
programme and other
options selection, otherwise
it can be cancelled if you
change some setting.
This option allows choosing the time
within which a programme should
terminate. The programme end can be
postponed by one 1 hour every button
touch until 24 hours maximum.
The display shows the normal
programme duration alternatively with
the set programme end time (expressed
in hours 0h). The minimum selectable
time corresponds to rounded up hour of
the maximum duration of a programme
(e.g. if the cycle duration lasts 3:15
hours, the minimum selectable time will
be 4h).
After programme start, the door is locked
and the appliance starts the ProSense
phase. When load estimation ends, on
the display the icon of running phase
blinks and the time digit counts down in
steps of one hour and in steps of 1
minute during the last hour.
7.5 Start / Pause
Touch the Start / Pause
start, pause the appliance or interrupt a
running programme.
7.6 Pods
Touch this button to activate or
deactivate the Pods option .
When activated the relevant indicator is
on.
Follow the Pods manufacturer's dosage
and storage recommendations.
Put maximum two tablets or single-dose
detergents in the Pods compartment in
the detergent dispenser drawer.
The option remains active also for next
cycles until it is deactivated and if it is
selectable with the set programme.
7.7 Plus Steam
This option adds a steam phase followed
by a short anti-crease phase at the end
of the washing programme.
The steam phase reduces fabric
creasing and facilitates the fabric ironing.
The recommended maximum load
decreases on the display.
The indicator
during steam phase.
When the programme stops the display
shows a zero
steady on and the indicator
blinking, and the Start / Pause
remains lit. The drum performs smooth
movements for about 30 minutes to keep
the steam benefit. By touching any
button the anti-crease movements stop
and the door unlocks, the appliance
proposes again the previous set
programme.
To interrupt the anti-crease phase, you
can also:
• Press the On/Off button for a few
• Turning the programme dial in
button to
blinks on the display
This option can affect the
programme duration.
, the indicator
seconds to activate or the deactivate
the appliance.
another position.
An half laundry load helps to
reach better results.
is
starts
led
Advertisement
Table of Contents
