Panasonic Lumix DMC-FX33 Operating Instructions Manual page 105

[WRITE ERROR
PLEASE CHECK THE CARD]
An error has occurred writing the data.
Turn the camera off and remove the card.
Insert the card again and turn the camera
on. Make sure the camera is turned off
before removing or inserting the card to
avoid damage.
[MOTION RECORDING WAS
CANCELLED DUE TO THE LIMITATION
OF THE WRITING SPEED OF THE
CARD]
• When you set the picture quality to
[30fpsVGA] or [30fps16:9], we
recommend using a high-speed card with
"10MB/s" or greater displayed on the
package.
• Depending on the type of SD Memory
Card or SDHC Memory Card, motion
picture recording may stop in the middle.
[A FOLDER CANNOT BE CREATED]
A folder cannot be created because there
are no remaining folder numbers that can
be used. (P92)
Format the card after saving necessary
data on a PC etc. (P90)
If you execute [NO.RESET] in the [SETUP]
menu after formatting, the folder number is
reset to 100. (P19)
[PICTURE IS DISPLAYED FOR 4:3 TV]/
[PICTURE IS DISPLAYED FOR 16:9 TV]
• The AV cable is connected to the camera.
Press [MENU/SET] if you want to delete
this message at once.
• Select [TV ASPECT] in the [SETUP]
menu if you want to change the TV
aspect. (P19)
• This message also appears when the
USB connection cable is connected to the
camera only.
In this case, connect the other end of the
USB connection cable to a PC or a printer.
(P91, 94)
[PLEASE RE-CONNECT THE PRINTER.]
This message will be displayed if you
change the mode dial to print mode [
while this unit is connected to a PC. If
connecting the printer again, change the
mode to a mode other than [
check that no data is being transferred.
( [ACCESS] appears on the LCD monitor of
this unit while data is being transferred.)
[USB MODE CHANGED. PLEASE
REMOVE THE USB CABLE.]
This message will be displayed if you
change the mode dial to a mode other than
print mode [
printer are connected.
Set the mode dial to [
disconnect the USB connection cable. If
printing, stop the printing and then
disconnect the USB connection cable.
[PRINTER BUSY]/[PLEASE CHECK THE
PRINTER]
The printer cannot print. Check the printer.
],
] and then
] while this unit and the
] again and then
Others
105
VQT1J82