Table of Contents
Advertisement
„ Shutter speed for each flash setting
„
Flash setting
q
@
t
`
The shutter speed becomes a maximum of 1 second in the following cases.
¼
– When the Optical Image Stabilizer is set to [OFF].
– When the camera has determined that there is little jitter when the Optical Image
Stabilizer is set.
• In Intelligent Auto Mode, shutter speed changes depending on the identified scene.
• In Scene Mode, shutter speed will be different from the above table.
Note
• If you bring the flash too close to an object, the object may be distorted or discolored by
the heat or lighting from the flash.
• When you take a picture beyond the available flash range, the exposure may not be
adjusted properly and the picture may become bright or dark.
• When the flash is being charged, the flash icon blinks red, and you cannot take a picture
even when you press the shutter button fully.
• The white balance may not be properly adjusted if the flash level is insufficient for the
subject.
• When using [Flash Burst] in Scene Mode or when the shutter speed is fast, the flash
effect may not be sufficient.
• It may take time to charge the flash if you repeat taking a picture. Take a picture after the
access indication disappears.
• The Red-Eye Reduction effect differs between people. Also, if the subject was far away
from the camera or was not looking at the first flash, the effect may not be evident.
Advanced (Recording pictures)
Shutter speed (Sec.)
1/60 to 1/1600
Flash setting
[
o
- 54 -
Shutter speed (Sec.)
1 to 1/1600
1 or 1/4 to 1/1600
Advertisement
Table of Contents
