Table of Contents
Advertisement
en Troubleshooting
Fault
The appliance is not
working.
The programme does
not start.
The door cannot
be opened.
46
Cause and troubleshooting
There has been a power cut.
Check whether the lighting in your kitchen or other
▶
appliances are working.
You have not pressed
Press
.
▶
Door is not closed.
Close the door.
1.
Press
to start the programme.
2.
Childproof lock is activated.
→ "Deactivating the childproof lock", Page 32
▶
is activated.
Check whether
▶
→ "Buttons", Page 23
Laundry is caught in the door.
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press
to start the programme.
4.
The detergent drawer has not been pushed in fully.
Push in the detergent drawer until the symbol goes
▶
out.
The pump for the intelligent dosing system is blocked.
Switch off the appliance.
1.
Clean the pump unit.
2.
→ "Cleaning the detergent drawer", Page 37
Switch the appliance on.
3.
If the display appears again after you clean the
4.
pump unit, call customer service.
→ "Customer Service", Page 55
Note: You can deactivate and manually dose the intel-
ligent dosing system until the fault is rectified.
→ "Buttons", Page 23
The detergent drawer has not been pushed in fully.
Push in the detergent drawer until the symbol goes
▶
out.
is activated.
Continue the programme by selecting Spin or
▶
Drain and pressing
→ "Resuming the programme when the programme
status is Rinse Hold", Page 32
.
is activated.
.
Advertisement
Table of Contents
