Ryobi RTS10NS Operator's Manual page 19

To adjust (horizontally and vertically):
 Remove the anti-kickback pawls and blade guard
assembly.
 From the back of the saw, loosen the screws holding the
mounting bracket.
 Reposition the riving knife left or right as needed to align
the riving knife with the saw blade.
 Once properly aligned, securely retighten all screws.
 Check again for squareness and continue to adjust if
needed.
HORIZONTAL ADJUSTMENT
RIVING
KNIFE
BLADE
VERTICAL ADJUSTMENT
RIVING
KNIFE
BLADE
ASSEMBLY
PUSH STICK STORAGE
See Figure 16.
 Insert the push stick storage screws from the loose parts
bag into the holes on the side of the saw table. Use a
Phillips head screwdriver to tighten screws securely.
 Place the slots in the push stick over the screws and slide
the push stick toward the back of the saw.
FRAMING
SQUARE
FRAMING
SQUARE
Fig. 15
19 - English
PUSH STICK STORAGE
SCREW(S)
PUSH STICK
Fig. 16