How To Set Up The System (Connection) - Panasonic AK-HC910 Operating Instructions Manual

How to Set Up the System (Connection)

_ Connection of remote control box
• Use multi-cable for the connection of HD controller AK-HRP900 and this unit.
AK-HC910P
NOTE
Note that the monitor output is
attenuated and deteriorated if
the cable is too long.
1 Before connecting the cables, be sure to set the Power Switch of AC Adaptor and HD
Controller to OFF.
2 Connect the multi-cable to the interface connector of the camera, and the opposite side
to HD Controller.
3 Set the AC Adaptor Power Switch to ON, and the HD Controller Power Switch to ON,
then the camera can be controlled.
4 After shooting, set the HD Controller Power Switch to OFF, and the AC Adaptor Power
Switch to OFF.
B R E A K E R
Coaxial Cable
Z O O M /
F O C U S
HD-SDI
(5C-FB)
1
S D I O U T
D-sub 15-pin
2
1 / F
Multi-cable (5m)
AK-HDMLTCA05
D-sub 15-pin
HD Monitor
Video
Input
Signal
HD Monitor
YPbPr
O I
AC Adaptor
AW-PS505
HD Controller
AK-HRP900
9
External
sync
signal
(3 value
sync)
DC Power
Cable