Removal And Replacement Of Parts; Inside Fresh-Food Compartment; Door Seal; Light Assembly - Frigidaire FFBN1721TV0 Technical & Service Manual

Service Manual - Four-door Refrigerator ( FFBN1721TV0 )

Removal and Replacement of Parts

Removal and Replacement of Parts
TO REINSTALL OR REPLACE PARTS,
NOTE REVERSE THE REMOVAL PROCEDURES
IN PROPER ORDER.
BEFORE SERVICING THE UNIT, TURN
OFF ELECTRICAL SUPPLY TO THE UNIT.
CAUTION

Inside Fresh-food Compartment

Door Seal

Door seal is installed into the door liner groove.
1. Open the refrigerator door.
2. Hold the door seal and pull out as shown in Figure 1.

Light Assembly

Light inside the fresh-food compartment is located in the ceiling
of the chamber.
1. Disconnect power and open the refrigerator door fully.
2. Remove the refrigerator shelves.
3. Open the snaps of the lamp cover using a flat-head
screwdriver as shown in Figure 2 and remove the cover.
4. Open the snaps of the LED light using a flat-head
screwdriver as shown in Figure 3 and take the light assembly
out.
5. Disconnect the wire connector and remove the LED light.

Air Duct

1. Disconnect power and open the refrigerator door fully.
2. Remove the refrigerator shelves.
3. Remove the crisper boxes.
4. Remove crisper cover.
5. Remove the crisper support by removing 4 screws as shown
in Figure 4.
Page 16
Pull out
Figure 1
Fresh-food compartment
ceiling
LED light
Figure 2
Open snaps using
flat-head screwdriver
LED light
wire connector
Figure 3
Crisper support
Remove screws
Figure 4
Open snap using
flat-head screwdriver
Disconnect
Remove screw