Child Lock; Control Two J Vc Vcrs - JVC HR-S4500U Instructions Manual

Hide thumbs Also See for HR-S4500U:
Table of Contents

Advertisement

60
EN
N U M BER "1"
STO P

Child Lock

This feature allows you to prevent the operation of the VCR.
TURN VCR PO W ER O N
Press PO W ER .
1
EN GAGE CHILD LO CK
Press and hold POW ER on the remote control until the
2
Child Lock indicator ("—") appears on the front display
panel.
● Power turns OFF and the VCR cannot be turned on
from the POW ER button on the front panel.
● To cancel Child Lock, press and hold
remote until the VCR turns on. During timer record-
ing, pressing TIM ER also cancels Child Lock.
N O TES:
● When Child Lock is engaged, make sure to keep the remote
control out of the reach of children.
● Timer recording of programs that were previously set can be
performed while the Child Lock is engaged. The feature
remains in effect after the recording is finished.
Downloaded from:
https://www.usersmanualguide.com/
PO W ER
N U M BER "2"
1
2
3
2
4
5
6
7
8
9
TIM ER
0
4
1
PO W ER on the
SPECIAL FEATU RES (cont.)
Control Tw o JVC VCRs
The remote control is capable of controlling two J VC VCRs
independently; one set to respond to your remote control's A
code control signals and another set to respond to B code
control signals. The remote control is preset to send A code
signals because your VCR is initially set to respond to A code
signals. You can easily modify your VCR to respond to B code
signals.
UN PLUG VCR' S PO W ER
CO RD
Unplug from the AC outlet.
1
SET REMO TE CO N TRO L
CO DE
While holding down A/ B on the remote control, press
2
the N U M BER key "2" and then press STO P .
PLUG IN PO W ER CO RD
Plug back in to the AC outlet.
3
TURN VCR PO W ER O N
Press PO W ER on the remote.
4
The VCR will now respond only to B-code commands.
To set the VCR back to respond to A code signals, repeat the
same procedure as shown above except pressing N U M BER key
"1" instead of "2" in step 2 .
You can control two VCRs with the same remote control by
switching the remote's code between A and B (
pressing "1" for A-code commands and "2" for B-code
commands.
Step 2 ),

Advertisement

Table of Contents
loading

Table of Contents