Stand Mixer; Assembling The Stand Mixer - Oster 2384 User Manual With Recipes

The Stand Mixer

Assembling the Stand Mixer

Before assembling the mixer, be sure the speed
control dial is in the OFF position and the
electric cord is unplugged.
Attaching the Turntable
Place the revolving turntable into the base
of the stand by pressing the turntable into
the center hole of the adjustment slot until
it snaps into place.
Adjusting the Turntable
The turntable must be adjusted depending
upon which bowl size is being used (see
"Adding the Mixing Bowl"). To adjust,
press down on the turntable locator switch
and slide switch to the proper icon.
Attaching and Removing Mixer Head
To attach the mixing head, press in on the
mixer-release trigger, located at the rear of
the stand.
Place the mixer head on the stand so that the
metal pivot on the bottom of the mixer head
goes into the latched opening on the top of
the stand.
As you release pressure from the mixer-release
trigger, the top of the latch should clamp
around the metal pivot. Once the mixing head
is lowered into position, it will lock into place.
To raise the mixing head, press the head lock
button downward while pulling up on the
handle of the mixing head. Once unlocked,
the mixing head can be removed by pressing
the mixer release trigger.
Be sure the mixer head is securely in position
before using.
N : This mixer is NOT intended for use
OTE
away from the stand.

stand mixer

B B
ALL EARING
E
XTENSION
M
IXER
H
EAD
M
IXER
R
ELEASE
T
RIGGER
L O
ATCHED PENING
M -R
IXER ELEASE
T
RIGGER
M
ETAL
P
IVOT
S
TAND
5