Advertisement
Battery Installation
Remove the battery door, located on the
bottom of the detector, and install (2) AA
batteries (supplied). Be sure to note the
correct polarity for each battery
(See legends inside battery compartment).
Optional
12-volt SmartCord
To power SOLO S4 using 12-volts, simply
remove the power connector plug, and
insert the small end of the optional
SmartCord, (telephone-type connector) into
the modular jack on SOLO S4's right side.
Plug the lighter plug adapter into your
vehicle's lighter socket or accessory socket.
The SmartCord allows you to operate the
SOLO S4 on 12 volts DC negative ground only.
The lighter plug is a standard size and will
work in most vehicles. Of course,
your lighter socket must be clean
and properly connected for proper
operation.
NOTE: Depending on your vehicle the power
socket may either be continuously on, or it may
be switched on and off with your ignition switch.
Controls & Features
Insert SOLO S4's adjustable Windshield
Press the release button, and slide the
Windshield mount into one of its four locking
Receives laser signals from behind the vehicle.
Power-On Indication
Three LED's (green, yellow, red) mounted
between the PWR button and the display,
indicate power (blinking in battery mode,
solid when optional 12-volt power cord is
used). These also indicate the sensitivity
mode that the unit is in,( "H" for highway, "A"
for AutoSensitivity, and "C" for city).
Press the PWR button to turn SOLO S4 on.
Press and hold the PWR button to turn SOLO
The SOLO S4 will automatically shut off
4
EasyMount Slot
mount into this slot.
EasyRelease Button
positions.
Rear Laser Port
PWR
S4 off.
AutoPwr Feature
once the vehicle has
stopped moving for
approximately
25 minutes.
Advertisement
