Table of Contents
Advertisement
Tim eSca n
N ames of
special-effects
playback
Speed SP
Speed LP
Audio output
● When noise appears or the upper or lower part of the picture is distorted during TimeScan search, press
tracking with TV PRO G + or – button.
● The speed is shown during TimeScan in the upper right corner of the TV screen for approx. 5 seconds. (The display may be
distorted.)
● To resume normal playback, press
● When using the recorder's
too fast.
● Picture and audio may become distorted when the recording speed changes. When this happens, resume normal playback
once, and then try using TimeScan again.
● The picture may be noisy or there may be a loss of colour when you change the playback speed. (More noise will appear with
LP recordings.)
● Noise may appear or the upper part of the picture may be distorted during still, frame-by-frame playback, 2x search of LP
recordings, or depending on the tape being used.
● Picture may appear distorted in comparison to normal playback.
● Depending on the tape in use, noise may appear or the upper part of the picture may be distorted.
● In TimeScan mode there will be a time lag between the video and the audio and noise may appear in the audio signal.
● TimeScan sound quality will differ in comparison to normal playback.
● When material such as music videos where there is non-stop sound (very few breaks in the soundtrack) are viewed at 2x
normal speed, the audio playback may be faster than normal.
● When the playback direction is reversed, it takes approximately 6 seconds until sound is heard.
● Picture will be monochrome with an LP-recorded MESECAM tape during TimeScan.
● TimeScan does not work with NTSC playback.
If you don't want to hear TimeScan audio, set "TIM E SCAN AU D IO " to "O FF" (See below).
TimeSca n Audio
The audio output can be set ON/OFF during TimeScan. Select ON/OFF as required.
* The default setting is "ON".
1
Press M EN U to access the Main Menu screen.
Move the highlight bar (pointer) to "MODE SET" by pressing %fi , then press O K or
2
Move the highlight bar (pointer) to "TIME SCAN AUDIO"
3
by pressing %fi , then press O K or
4
Press M EN U to return to the normal screen.
Downloaded from:
https://www.usersmanualguide.com/
Reverse
Search
Play
-9x -7x -5x -3x
-1x
-7x
-3x
Audio is output.
** Still mode cannot be engaged using the remote control's
pressing the PAU SE button.
PLAY .
TIM E SCAN SH U TTLE ring, the playback speed may not change in the correct step if it is turned
to select "ON" or "OFF".
#
Slow-Motion
*Still
Slow-Motion
-1/6x -1/18x
0
1/18x
-1/6x -1/18x
0
1/18x
Audio is not
Audio is
Audio is not
output.
output.
or
@
MODE SET
B. E. S. T.
PICTURE CONTROL
AUTO TIMER
O. S. D.
DIRECT REC
AUTO SP=LP TIMER
POWER SAVE
NEXT PAGE
[5∞] =
[MENU] : EXIT
Forward
Play
1/6x
1x
2x 3x 5x 7x 9x
1/6x
1x
2x
Audio is output.
output.
button. Still mode can be engaged by
#
and adjust
.
#
PREVIOUS PAGE
ON
AV2 SELECT
AUTO
COLOUR SYSTEM PAL/NTSC
OFF
TIME SCAN AUDIO
ON
ON
OFF
OFF
[5∞] =
[MENU] : EXIT
19
EN
Search
5x
9x
AV2
ON
Advertisement
Table of Contents
