Uestio N S An D An Sw Ers 6; Pla Yba; Recording; Timer Recording - JVC HR-DD840U Instructions Manual

62
EN
PLAYBACK
Q . W hat happens if the end of the tape is reached
during playback or search?
A. The tape is automatically rewound to the beginning.
○ ○ ○ ○ ○ ○ ○ ○ ○
Q . Can the VCR indefinitely remain in the still mode?
A. No. It stops automatically after 5 minutes to protect
the heads.
○ ○ ○ ○ ○ ○ ○ ○ ○
Q . D uring search, still and frame-by-frame playback,
the picture is intermittent. W hat's the cause?
A. Picture loss occurs when these types of playback are
attempted with a tape recorded in LP mode. Pressing
PLAY to return to normal playback will restore the
picture.
○ ○ ○ ○ ○ ○ ○ ○ ○
Q . W hen returning from multi-speed search to normal
playback, the picture is disturbed. Should I be
concerned about this?
A. No, it is normal.
○ ○ ○ ○ ○ ○ ○ ○ ○
Q . W hen playing back programs that have been timer-
recorded with consecutive times (such one program
from 8:00 to 9:00 and another one from 9:00 to
10:00), the picture becomes momentarily distorted
at the point where the first program ends and the
second program begins. Is this a malfunction?
A. No. This is normal.
○ ○ ○ ○ ○ ○ ○ ○ ○
Q . O ther than preventing further recording, what effect
does removing the safety tab have?
A. It disables marking of index codes.
○ ○ ○ ○ ○ ○ ○ ○ ○
Q . Sometimes, during Index Search, the VCR can't find
the program I want to see. W hy not?
A. There may be index codes too close together.
○ ○ ○ ○ ○ ○ ○ ○ ○
Q . D uring playback, on-screen operational indicators
sometimes jitter. W hy does this happen?
A. If the condition of the tape being played back is not
good, jittering of the video (including on-screen
indicators) may occur.
Downloaded from: https://www.usersmanualguide.com/
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Q U ESTIO N S AN D AN SW ERS

RECORDING

Q . W hen I pause and then resume a recording, the end
of the recording before the pause is overlapped by
the new recording. W hy does this happen?
A. This is normal. It reduces distortion at the pause and
○ ○ ○ ○ ○ ○
resume points.
○ ○ ○ ○ ○
Q . Can the VCR indefinitely remain in the Record-Pause
mode?
○ ○ ○ ○ ○ ○
A. No. The VCR automatically goes to its Stop mode
after 5 minutes to protect the heads. When paused
during Instant Timer Recording (ITR), the VCR shuts
off automatically after 5 minutes.
○ ○ ○ ○ ○
Q . W hat happens if the tape runs out during recording?
A. The VCR automatically rewinds it to the beginning.
○ ○ ○ ○ ○ ○
TIM ER RECORDING
Q . REC and TIM ER remain lit on the front display panel.
Is there a problem?
A. No. This is a normal condition for a timer recording
○ ○ ○ ○ ○ ○
in progress.
○ ○ ○ ○ ○
Q . Can I program the timer while I'm watching a tape
or a TV broadcast?
A. Yes, but while you are setting the timer you won't see
the tape's or broadcast program's picture as it is
replaced by the on-screen menu. The audio from the
tape or broadcast program will be present during the
○ ○ ○ ○ ○ ○
setting of the timer.
○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○