Advertisement
Un-install the brackets:
MAINTENANCE
When handled properly, this unit is engineered to give you years
of satisfactory service. Here are a few product care instructions:
1. Do not immerse the unit in water. If the unit comes in contact
with water, dry it immediately with a soft lint-free cloth.
2. Do not clean the unit with abrasive or corrosive materials.
Abrasive cleaning agents may scratch the plastic parts and
corrode the electronic circuit.
3. Do not subject the unit to excessive: force, shock, dust, tem-
perature, or humidity. Such treatment may result in malfunc-
tion, a shorter electronic life span, damaged batteries, or
distorted parts.
4. Do not tamper with the unit's internal components. Doing so
will terminate the unit's warranty and may cause damage.
The unit contains no user-serviceable parts.
5. Only use new batteries as specified in this instruction manual.
Do not mix new and old batteries as the old batteries may
leak.
6. Read this instruction manual thoroughly before operating the
unit.
SPECIFICATIONS
Main unit
Proposed operating range : - 5.0 C to 50.0 C
Temperature resolution
Relative Humidity
Remote thermo-hygro unit
Proposed operating range : -20.0 C to 60.0 C
Temperature resolution
Relative Humidity
( 23.0 F to 122.0 F)
: 0.1 C to ( 0.2 F)
: 25% RH to 95% RH
Operating range
( -4.0 F to 140.0 F)
: 0.1 C to ( 0.2 F)
: 25% RH to 95% RH
Operating range
General
RF Transmission Frequency : 433 MHz
No. of Remote unit
RF Transmission Range
Temperature compensation : 0.1 C to ( 0.2 F)
Temperature sensing cycle
Power
Main unit
Remote sensing unit
Weight
Main unit
Remote sensing unit
Dimensions
Main unit(H xW xD)
Remote sensing unit
NOTE ON COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1)This device may
not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause
undesired operations.
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user's authority to operate the equipment.
FCC :
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
5
: Maximum of 3
: 100 feet
: around 40 seconds
: 2 pcs UM-3 or "AA" 1.5V
alkaline battery
: 2 pcs UM-4 or "AAA" 1.5V
alkaline battery
: 4.47 ounces
: 3.17 ounces
: 6.54" x 2.28" x 1.26"
: 6.54" x 1.57" x 1.33"
Advertisement
