Battery Replacement - Dimplex B075E Instruction Manual

Battery Replacement

This product is fitted with a replaceable battery in the controls. To replace the battery, follow
the steps below, shown in Fig. 7
1. Unhinge the heater from the wall using the clips shown in Fig. 2 and locate the battery module
2. Slide the catch and pull module from the controls.
3. Remove the coin cell battery and replace with a new CR2032 3V button cell battery.
4. Slide module back in place, ensuring clip is engaged.
CONTROLLER BATTERY REPLACEMENT
Battery power will only be used when there is no power to the unit
Expected battery life is 5 years
Should you need to replace the battery, please use a CR 2032 3V
button cell type b
no power to the unit
Important
During the initial operation, some odour may be noticed due to the newness of materials used
in manufacture. This is normal and will disappear after a short period of use. It is however
advisable to keep the room well ventilated.
Cleaning
WARNING - ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE
CLEANING THE HEATER.
Before commencing cleaning, isolate the heater from the electrical supply and allow it to
cool. The outside can be cleaned by wiping it over with a soft damp cloth and then dried.
Do not use abrasive cleaning powders or furniture polish, as this can damage the surface finish.
attery. Power will only be used when there is
Fig. 7
24