Table of Contents
Advertisement
3. After a few times, the LCD will display as shown below:
Special Note :
Due to certain reason, when the following conditions occur, the aging will stop but the count value shall be maintained:
· During OPEN operation, after a certain timing, the CD does not open in the OPEN position. (After REST SW is OFF, the CD
OPEN SW did not turn ON after 4s.)
· During CLOSE operation, after a certain timing, the CD does not close in the CLOSE position. (After CLOSE operation, REST
SW was not turned off in 4s.)
· After 10s, the Disc Access has not yet complete.
· Out of Focus for more than 2s.
12.2.5. Cassette Aging Test (SG2)
· Purpose : To check the reliability of the SG2 mechanism.
− − − − Operation: After entering the doctor mode, press [
the process is as below:
− − − − Stop Operation: Use Stop key (main set). If stop key is pressed, aging test will stop and remain in doctor mode.
· Procedures :
1. Enter into doctor mode (Refer to section 12.2).
2. Press [
/+ /FF] on the main unit. it will enter into the casette aging mode.
Figure 12-5
/+ /FF] key on the main set for 2sec, it will enter the Aging Test where
SG2 Aging Test
35
RX-ES29EE
Advertisement
Table of Contents
