Table of Contents
Advertisement
Per 100FX SFP Slot (Port 5 of ISW-514PTF)
LED
Color
LNK/
Green
ACT
2.3 Switch Upper Panel
The upper panel of the Industrial PoE+ Switch consists of one terminal block
connector within two DC power inputs.
Figure 2-3 shows the upper panel of the Industrial PoE+ Switch.
2.4 Wiring the Power Inputs
The 6-contact terminal block connector on the top panel of Industrial PoE+
Switch is used for two DC redundant power inputs. Please follow the steps
below to insert the power wire.
When performing any of the procedures like inserting the wires
or tightening the wire-clamp screws, make sure the power is
OFF to prevent from getting an electric shock.
Lights: indicates the link through that port is successfully
established at 100Mbps.
Blinks: indicates that the switch is actively sending or
receiving data over that port.
Max. Fault Alarm Loading: 24V, 1A
1 2 3 4 5 6
DC Input:
V1+
12-54V
, 7A max.
PWR1
Figure 2-3: Industrial PoE+ Switch Upper Pane
Function
V2+
Alarm
PWR2
7
Advertisement
Table of Contents
