Receiving Inspection Hanging/Installation Requirements Unless local building codes require hangers, the basic Prior to removing the shipping materials, visually inspect the XG-Round Retrofit Air Terminals may be light enough to be packing materials. There should be a black plastic strip wrapped supported by the ductwork itself.
Figure 2 Trapeze Minimum Clearance for Access Connecting Duct Work Slip each inlet duct over the inlet collar of the XG-Round Dual Duct Air Terminals require sufficient space to allow servicing Retrofit Air Terminal. of the controls. Horizontal clearance requirements are dependent Fasten and seal the connection by method upon access panel dimensions which are indicated on the ap- prescribed by job specification.
Field Electrical Wiring Labeling All field wiring must comply with local building codes and XG-Round Retrofit Air Terminals are shipped from the factory with NEC. (ANSI/NFPA 70-2002) multiple information labels. When Applicable, electrical control and piping diagrams are attached to exterior of XG-Round Retrofit Air Terminal. Control Sequence Label: Affixed to the exterior of the Use copper only conductors.