Table of Contents
Advertisement
I N S T A L L A T I O N
Setting Up the Player - Easy Setup Wizard
Access the Easy Setup Wizard
When the player is turned on for the first time, an Easy Setup Wizard screen will appear. It is a series of
guided instructions designed to configure the basic settings for the player.
To start the Easy Setup Wizard, please follow these steps:
1) Turn on the TV.
2) Turn on the player.
3) Switch the input selection on your TV so that the TV displays the signal from the player. You
should see the first step of the Easy Setup Wizard.
If the Easy Setup Wizard has previously been completed or cancelled, it will no longer initiate when you turn
on the player. Instead, you will see the background screen with the OPPO and Blu-Ray Disc logos. To
access Easy Setup Wizard, please press the SETUP button on the remote control, select Device Setup, then
Easy Setup
Step: 1/6
The Easy Setup Wizard will help you configure the
basic settings for this player. More detailed settings
can be accessed at the Setup Menu at any time after
finishing or exiting the wizard.
Press OK to initiate the Easy Setup Wizard, press
Cancel to exit this Wizard immediately.
Choose the Primary Video Output
Easy Setup
Step: 2/6
Choose the primary video output that you use.
Better performance will be provided over an HDMI
connection.
Previous
To make your selection, use the UP/DOWN ARROW buttons to highlight the choice, and then press the
ENTER button to go to the next step.
Reset Factory Defaults. Select "OK" to confirm
loading the factory default settings. Once the
factory default settings are loaded the Easy Setup
Wizard will appear.
The first step of the Easy Setup Wizard gives you
the opportunity to skip the entire wizard. If you are
familiar with setting up audio/video equipment and
would like to customize the player settings using
its Setup Menu, you may use the LEFT/RIGHT
ARROW buttons to select the "Cancel" option,
then press the ENTER key to exit the Easy Setup
Wizard. Otherwise, to continue with the Easy
Setup Wizard, select the "OK" option and press
the ENTER key.
The player can output video through its HDMI and
component output terminals. (Composite video
and S-Video outputs are also available but not
recommended.) By setting the "Primary Video
HDMI
Output" option, the player can optimize video
output of the selected terminal. The choices are
"HDMI" and "Component". If you connect the
player to the TV using an HDMI cable (Method 1
Component
on page 10, Method 2 on page 11, or Method 4 on
page 13), please select "HDMI". If you connect
the player to the TV using component video cables
(Method 3 on page 12), please select
"Component". Please note: the best performance
Next
will be provided over the HDMI connection.
18
Advertisement
Table of Contents
