Bluetooth Messages From The Microsoft Windows System; Resetting The Recorder With The Microsoft Windows App - GE SEER 1000 Operating Manual

Troubleshooting
Bluetooth Messages from the Microsoft Windows
System
Certain problems when establishing Bluetooth connectivity between PC
and recorder are reported by the operating system of the PC.
The app tries to suggest a solution but cannot always determine the rea-
son of the problem. In this case, the system messages and the respective
error codes are displayed. These messages and error codes can be inter-
preted by the Windows system administrator.
You can try the following:

Check if Bluetooth is enabled on the recorder and try again.

If a recording is running, press and hold the Event Button until the
multi-beep indicates wireless connectivity is activated.

On the PC application device, disable any built-in Bluetooth module.
Refer to the section "How to Disable a Built-in Bluetooth Module" on
page 70.

Resetting the Recorder with the Microsoft Windows App

NOTICE
Resetting the recorder deletes all the data on the recorder and resets
the protection key.
The recorder can be reset as follows:
1.
2.
3.
90
Switch on the recorder.
Start the app.
Type "administrator" in the first line of the Login window.
SEER™ 1000 2067634-077 Revision B