Onkyo TX-SR505 Instruction Manual page 75

STANDBY/ON
INPUT SELECTOR
Number
1
buttons
V CR/DVR
CBL/SAT
4
AUX MULTI CH
7
TAPE TUNER
10
D TUN
+ 10
D TUN
--/--- DIMMER
TV
INPUT
GUIDE
TOP MENU
SP A / B
PLAYLIST/CAT
SETUP
LISTENING MODE
STEREO SURROUND
AUDIO SUBTITLE
TEST TONE
Selecting SIRIUS Satellite Radio Channels
There are three ways to select SIRIUS Satellite Radio
channels:
• Channel Search mode: select any channel.
• Category Search mode: select channels by category.
• Direct tuning: enter channel number.
■ Channel Search Mode
1
Press the [RECEIVER] button,
followed by the [ENTER] button
RECEIVER
to select "Channel Search"
mode.
2
Use the Up and Down [
buttons to select a channel.
Channel number
You can also use the Left and Right
[ ]/[ ] buttons to select a category.
REMOTE MODE
RECEIVER
RECEIVER DVD
TAPE/AMP
M D/CDR
C D
2 3
DOCK
T V
5 6
DVD
VCR
8 9
C D
CABLE
11 12
0 CLR SAT
ENT
ENT
SLEEP
CH
VOL VOL
DISC
ALBUM
PREVIOUS
MENU
MUTING
ENTER
ENTER
PLAYLIST/CAT
RETURN
RANDOM REPEAT
LEVEL - LEVEL +
CH SEL
]/[
Channel name
■ Category Search Mode
1
RECEIVER
2
■ Direct Tuning
You can select a SIRIUS Satellite Radio channel directly
by entering its number.
1
RECEIVER
D TUN
2
1 2 3
VCR/DVR CBL/SAT
4 5 6
AUX MULTI CH DVD
7 8 9
TAPE TUNER C D
11 12
0
CLR
ENT
DIMMER SLEEP
]
Notes:
• If you select an unavailable channel, "INVALID
CHANNEL" appears on the display.
• If you select a channel that you are not subscribed to,
"CALL SIRIUS" appears on the display.
• If you select a channel that is locked, you'll need to
enter your 4-digit PIN number to listen to that channel.
See "Parental Lock" on page 5 for more information.
Press the [RECEIVER] button,
followed by the [ENTER] button
to select "Category Search"
mode.
Use the Left and Right [
buttons to select a category, and
use the Up and Down [
buttons to select a channel in
that category.
Press the [RECEIVER] button,
followed by the [D TUN] button.
The [RECEIVER] button flashes.
Within 8 seconds, use the num-
ber buttons to enter the channel
number.
The channel is selected.
For example, to select channel #20,
press 0, 2, 0, or 2, 0, [ENT].
Note: While the [RECEIVER] button is
flashing, the input source cannot be
changed by using the remote controller.
]/[ ]
]/[ ]
3