Controlling Zone 2 Components - Onkyo TX-NR709 Instruction Manual

Controlling Zone 2 Components

■
Operating on the AV receiver
Input selector buttons
ZONE 2 OFF
1
To turn on Zone 2 and select an input source, press
ZONE 2 followed by an input selector button
within 8 seconds.
Zone 2 turns on, the Z2 indicator lights on the
display.
Tip
• The corresponding trigger output goes high (+12 V).
To select AM or FM, press the TUNER input selector
button repeatedly.
To select the same source as the main room's, press
ZONE 2 repeatedly until "Z2 Selector: Source"
appears on the display.
To turn off Zone 2, press OFF.
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
■
Operating on the remote controller
To control Zone 2, you must press ZONE2 on the remote
controller first.
1
Press ZONE2 and then press 8RECEIVER.
Zone 2 turns on, the Z2 indicator lights on the
display.
Tip
• The corresponding trigger output goes high (+12 V).
En
64
MASTER VOLUME
8RECEIVER
ZONE2
Input selector buttons
MUTING
VOLq/w
2 To select an input source for Zone 2, press ZONE2,
followed by an input selector button.
To select AM or FM, press the TUNER input selector
repeatedly.
Note
• You cannot select different AM or FM radio stations for
your main room and Zone 2. The same AM/FM radio
station will be heard in each room.
3
To turn off Zone 2, press ZONE2 followed by
8RECEIVER.
Tip
• The corresponding trigger output goes low (0 volts).
Adjusting the Volume for Zone 2
■
Operating on the remote controller
1 Press ZONE2.
2
Use VOL q/w to adjust the volume.
■
Operating on the AV receiver
1 Press ZONE 2 (the Z2 indicator on the display
flash).
2 Use MASTER VOLUME control within 8 seconds
to adjust the volume.
If your Zone 2 speakers are connected to a receiver or
integrated amp in Zone 2, use its volume control to adjust
the volume.