Using The Tuner; Listening To The Radio; Tuning Into Radio Stations - Onkyo TX-8011 Instruction Manual

TX-8011_E.book Page 19 Friday, July 30, 2004 10:33 AM

Using the Tuner

With the built-in tuner, you can enjoy AM and FM radio
stations, and you can store your favorite stations as pre-
sets for quick selection.
TUNING
MEMORY
DIRECT TUNING
FM/AM

Listening to the Radio

1 Press the [FM] or [AM] button.
or
Press the remote controller's
INPUT SELECTOR [TUNER] but-
ton (This will select the last sta-
tion selected. You cannot switch
between AM and FM with the
remote controller.)
In this example, FM has been selected.

Tuning into Radio Stations

When tuned into a stereo FM station, the
TUNED and STEREO indicators appear on the
display, as shown.
When tuned into an AM station, only the
TUNED indicator appears.
Auto Tuning Mode (FM only)
1
Press and hold the TUNING Up or
Down [ ]/[ ] button for more
than 0.5 seconds.
Searching stops when a station is
found.
Number
VOLUME
GROUP
SCAN
FM MUTE
ON
MHz CH
Band Frequency
FM MUTE TUNED
ON STEREO
CH
MHz
Manual Tuning Mode
1 Press the TUNING Up or Down
[ ]/[ ] button.
Press the buttons repeatedly to change
the frequency one step at a time.
The FM frequency changes in 0.1 MHz steps; 10 kHz
steps for AM.
Direct Tuning Mode
1 Press the [DIRECT TUNING] but-
ton.
"_ _ " will flash for 16 seconds on the
display.
2
While the underscore characters
are flashing, use the number but-
tons to enter the frequency.
For example, to enter 88.1 MHz, press
[8], [8], [1].
Tuning into weak FM stations
If you tune in a stereo FM station, the STEREO indicator
will appear if the signal is strong enough. If the signal is
weak, it may not be possible to tune into the station. In
this case, press the [FM MODE] button. The FM MUTE
OFF indicator will appear, the station will be in mono,
and there may be some interstation noise.
19