Connecting The Speakers; Connecting The Power Cord; Adjustment; Connecting The Speaker Cables - Onkyo HT-S570 Instruction Manual

Connecting the
Speakers
Read the following before connecting your speakers:
• Turn off your amp before making any connections.
• Pay close attention to speaker wiring polarity. Connect
positive (+) terminals to only positive (+) terminals,
and negative (–) terminals to only negative (–) termi-
nals. If the speakers are wired incorrectly, the sound
will be out of phase and will sound unnatural.
• Be careful not to short the positive
and negative wires. Doing so may
damage your amp.

Connecting the Speaker Cables

1 Use the cables to connect each speaker's
input terminals to the corresponding
speaker output terminals on your
HT-R320 or other receiver.
To make a connection, while
pressing the terminal lever,
insert the wire into the hole, and
then release the lever.
Make sure that the terminals are
gripping the bare wires, not the insulation.

Connecting the Subwoofer

1
Using the supplied RCA cable, connect
the subwoofer's LINE INPUT to your
amp's SUBWOOFER PREOUT.
6
Connecting the Power
Cord
Notes:
• Before connecting the power cord, connect all of your
speakers and AV components.
• Turning on the SKW-320X may cause a momentary
power surge that might interfere with other electrical
equipment o the same circuit. If this is a problem, plug
the SKW-320X into a different branch circuit.

Adjustment

Setting the Subwoofer Level
To set the level of the subwoofer, use the OUTPUT
LEVEL control. Set it so that bass sounds are evenly bal-
anced with the treble sounds from the other speakers.
Because our ears are less sensitive to very low bass
sounds, there's a temptation to set the level of the sub-
woofer too high. As a rule of thumb, set the subwoofer
level to what you think is the optimal level, and then
back it off slightly.
OUTPUT
LEVEL
MAX
MIN