Compaq LP8000-F1 User Manual page 78

7-8 Compaq StorageWorks 64-Bit PCI-To-Fibre Channel Host Bus Adapter User Guide
4. Boot your computer with the supplied Smart-Start CD version 4.30A.
5. Run the system erase utility. Your computer will have to be power
cycled, but leave CD in.
6. When your computer boots, choose Installation using your language.
7. Set the Region Properties (time and date).
8. Select agree to Compaq Smart-Start Licensing prompt and then click
Next.
9. Choose Manual Configuration instead of the defaulted Assisted
Integration.
10. Select OS-Microsoft NT 4.0 for Select and then click Next.
Verify OS type and then click Next.
12. Smart-Start prompts to create support diskettes. Proceed without
creating these diskettes, after which the computer reboots and starts the
System Configuration Utility.
13. After the System Configuration Utility runs, save the settings and
reboot.
14. Use an MS-DOS boot diskette to boot your computer.
15. Insert the HBA driver diskette and run the I386DNLD.EXE diagnostic
utility.
16. Enter the Firmware Maintenance option and enable the Boot BIOS. Exit
the I386DNLD.EXE program.
17. Reboot your computer using the MS-DOS boot diskette to verify your
computer is operating properly.
18. Power your computer down.
19. Boot your computer using the MS-DOS boot diskette.
20. Press the F5 key when prompted to enter the HBA BIOS utility.
21. Select the HBA detected.
22. Select a device on the HBA that you designate as the boot device.
Choose device 01.
23. Return to the previous menu and enable the Boot BIOS on the HBA.
24. Enable the BIOS on the selected drive.