Table of Contents
Advertisement
V ideo
Cha nnel Set
Video Channel (RF Output Channel) is the channel on
which your TV receives picture and sound signals from the
video recorder through the RF cable.
TEST SIGN AL
To view picture signals from the video recorder, set
your TV to the Video Channel.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Be sure to connect the power plug to an AC outlet first
before installing the lithium battery; otherwise, the
battery's service life will be drastically shortened.
Downloaded from:
https://www.usersmanualguide.com/
2
q
5/8
The channel on which the screen to
the left appear clearly in step 3 is
your Video Channel.
The video recorder is designed to send picture and sound
signals via the connected RF cable to your TV on UHF channel
36.
After you have turned on the recorder, set your TV to UHF
channel 36, fine-tune as necessary, and check if picture and
sound being received from the recorder come out clearly or not:
● If clear enough
● If not
Before starting, make sure of the following:
● The recorder's power should be off.
● No cassette should be inserted in the recorder.
● The connected TV's power should be on.
3
SET TV CHAN N EL
1
Set your TV to a channel between 32 and 40 that you
want to use as the Video Channel on the TV.
BRIN G TEST SIGN AL O N
SCREEN
2
Hold down the recorder's STO P/ EJECT button for more
than 5 seconds.
● "– OUT" appears on the display panel.
TUN E YO UR RECO RDER
3
Turn the RF output channel adjustment screw on the
rear panel of the recorder by using a screwdriver until
the two vertical bars become as clear as they can be.
EXIT VIDEO CHAN N EL SET
MO DE
4
Press the recorder's STO P/ EJECT button again to finish
the setting.
Installing/ Removing the lithium battery
1
Make sure that the power plug is connected to an AC outlet
and turn off the VCR power.
2
Open the battery cover while pressing the release tab as
illustrated.
3
Insert a lithium battery with the plus (+) side up and push it
in.
To remove the lithium battery, press the latch A down-
●
ward using a pointed non-metallic object, then pull out
the lithium battery.
4
Close the battery cover until it clicks in place.
A
you don't have to perform the following
steps. Go to "Installing/Removing the
lithium battery" on this page.
UHF channel 36 or neighbouring channels
may be occupied by local stations. Perform
the following steps to change the Video
Channel to another channel between
32 – 40.
5
EN
Advertisement
Table of Contents
