Table of Contents
Advertisement
IN241900AV
MODEL
NOZZLE
AT125102AJ
Ceramic
AT121002AJ
Ceramic
AT121102AJ
Ceramic
Assembly
HOSE CONNECT ASSEMBLY FOR
MODEL AT125102AJ - 30 LBS
1. Attach the material hose to the hose connector.
Attach the opposite end of the material hose to the
gun (See Figure 4).
NOTE: DO NOT cover the hole in the hose connector
for dry blasting. For use with liquids, slip the material
hose fully on the hose connector covering the hole.
2. Attach the air compressor hose to the opening at the
bottom of the gun handle. An optional 1/4" NPT
quick connector (MP2468) and coupler (MP2883)
can be used to attach the hose to the gun.
HOSE
CONNECTOR
Figure 4 _ Model AT125102AJ - 30 LBS
HOSE CONNECT ASSEMBLY FOR
MODEL AT121002AJ - 60 LBS
1. Attach the hose connector to the hopper using the
conduit nut.
2. Attach the material hose to the hose connector.
Attach the opposite end of the material hose to the
gun (See Figure 5).
NOTE: DO NOT cover the hole in the hose connector
for dry blasting. For use with liquids, slip the material
hose fully on the hose connector covering the hole.
3. Attach the air compressor hose to the opening at the
bottom of the gun handle. An optional 1/4" NPT quick
connector (MP2468) and coupler (MP2883) can be
used to attach the hose to the gun.
HOPPER AND HOSE CONNECT ASSEMBLY
FOR MODEL AT121102AJ - 120 LBS
1. Slide the wheel onto the axle and lightly hammer on
the wheel cap. Make sure the protruding hub on the
wheel is facing the hopper (See Figure 6). Repeat for
the opposite side.
2. Attach the hose connector to the hopper using the
conduit nut.
MODELS AT125102AJ, AT121002AJ AND AT121102AJ
Specifications
HOPPER
CAPACITY
30 lbs
60 lbs
120 lbs
MATERIAL
HOSE
ATTACH
AIR
HOSE
DO NOT COVER
THIS HOLE FOR
DRY BLASTING
MAXIMUM
PSI
REQUIRED
125
125
125
ATTACH
AIR
HOSE
MATERIAL
HOSE
CONNECTOR
Figure 5 _ Model AT121002AJ - 60 LBS
3. Attach the material hose to the hose connector.
Attach the opposite end of the material hose to the
gun (See Figure 6).
NOTE: DO NOT cover the hole in the hose connector
for dry blasting. For use with liquids, slip the material
hose fully on the hose connector covering the hole.
4. Attach the air compressor hose to the opening at the
bottom of the gun handle. An optional 1/4" NPT
quick connector (MP2468) and coupler (MP2883)
can be used to attach the hose to the gun.
PROTRUDING
HUB
ATTACH
AIR
HOSE
HOSE
CONNECTOR
MATERIAL
HOSE
Figure 6 _ Model AT121102AJ - 120 LBS
__
__
2
HP
MINIMUM
CFM
1 or more
2.2 @ 40 PSI
2 or more
2.2 @ 40 PSI
2 or more
2.2 @ 40 PSI
CONDUIT
NUT
DO NOT
COVER
THIS HOLE FOR
HOSE
DRY BLASTING
CONDUIT
NUT
DO NOT
COVER
THIS HOLE
FOR DRY BLASTING
WHEEL
CAP
Advertisement
Table of Contents
