Copying System Diskettes - TRIGEM CW3D25C Operation Manual

8

Copying System Diskettes

Now that you have started your system and loaded MS-DOS, it
is important that you make copies of your MS-DOS diskettes
right away. Use the copies (called working copies) as they are
needed and store the originals in a safe place.
Each of the system diskettes is formatted for 360KB.
(Formatting prepares a diskette to store data and is described in
Chapter 3 and Chapter 5.)
To copy them, you need seven 360KB doubledensity, 5¼-inch
diskettes.
N o t e
If you do not have any 360KB diskettes, you can use
unformatted 1.2MB diskettes.
diskettes, the DISKCOPY program formats the 1.2MB
diskettes for 360KB.
Follow these steps:
1. The C > prompt should be on the screen. If not, type C:
and press Enter.
2. Type the following and press Enter:
DISKCOPY A: A:
The screen displays this message:
Insert
Press
3. Insert the MS-DOS diskette in drive A, as shown below.
Hold the diskette with the label facing up and the
read/write slot into the drive.
1-16 Setting Up Your System
SOURCE diskette in drive A:
key to
any continue...
When copying from 360KB