Table of Contents
Advertisement
You should already have
stored on the hard disk that you want to save. Press Y to begin
formatting. The formatting process takes
When it is completed, the
F o r m a t t i n g
System transferred
Volume
Here, your computer is asking you to name your hard disk
drive. This is a result of the /V switch used with the FORMAT
command. A disk label can be useful when sorting directories,
so you may want to enter one now.
A volume label can use up to eleven characters. See Chapter
4, "Using MS-DOS," for a list of valid label characters. When
you have entered the drive label, your computer will respond:
XXXXXXXX bytes total disk space
XXXXX bytes used by system
XXXXXXXX bytes available on disk
The /S switch in the FORMAT command caused the active
portions of MS-DOS to be loaded onto the system area of the
hard disk. At this point you can boot the system from the hard
disk.
6-10
Using
Your
made sure
system will
label (11 characters, ENTER for none)?
Hard Disk
that there is no information
several
minutes.
display:
Advertisement
Table of Contents
