Kia Telluride 2023 Owner's Manual page 149

Features of your vehicle
Erasing programmed HomeLink
buttons
OON042505
To erase the three programmed buttons
(individual buttons cannot be erased):
僅 Press and hold the left and center
buttons simultaneously, until the indi-
cator light begins to flash (approxi-
mately 20 seconds). Release both
buttons. Do not hold for longer than
30 seconds.
HomeLink is now in the train (or learn-
ing) mode and can be programmed at
any time.
Reprogramming a single Home-
Link button
To program a device to HomeLink using
a HomeLink button that has already
been trained, follow these steps:
1. Press and hold the desired HomeLink
button. Do NOT release until step 4
has been completed.
2. When the indicator light begins to
flash slowly (after 20 seconds), posi-
tion the hand-held transmitter 1~3
inches (2~8 cm) away from the Home-
Link surface.
3. Press and hold the hand-held trans-
mitter button (or press and "cycle" - as
described in "Canadian Program-
ming").
4. The HomeLink indicator light will
flash, first slowly and then rapidly.
When the indicator light begins to
flash rapidly, release both buttons.
The previous device has now been
erased and the new device can be acti-
vated by pushing the HomeLink button
that has just been programmed. This
procedure will not affect any other pro-
grammed HomeLink buttons.
Canadian Programming Garage &
gate openers
During programming, your hand-held
transmitter may automatically stop
transmitting. Continue to press and hold
the HomeLink button (note steps 2
through 4 in "Programming HomeLink"
on page 4-67) while you press and re-
press ("cycle") your handheld transmitter
every two seconds until the frequency
signal has been learned. Upon success-
ful training, the indicator light will flash
slowly and then rapidly after several sec-
onds.
Accessories
If you would like additional information
on the HomeLink Wireless Control sys-
tem, HomeLink compatible products, or
to purchase other accessories such as
the HomeLink씾 Lighting Package,
please contact HomeLink at 1-800-355-
3515 or on the internet at www.home-
link.com.
FCC ID: NZLZTVHL3
IC: 4112A-ZTVHL3
This device complies with Part 15
of the FCC rules.
1. This device may not cause harmful
interference, and
2. This device must accept any interfer-
ence received, including interference
that may cause undesired operation.
The transceiver has been tested and
complies with FCC and Industry Canada
rules. Changes or modifications not
Mirrors
4
4 69