Sending Information To Your Printer - Epson LQ-1050X User Manual

You have seen how to design a character by placing dots on a grid
and translating the dots to decimal equivalents. The last step in
defining a character is sending this information to your printer.

Sending Information to Your Printer

The printer loads characters in the print style (Letter Quality, draft,
or proportional) that the printer is currently using. It also records
whether italic, superscript, or subscript is turned on. This means
that if you want to print a character in italics, for example, you must
have the italic mode turned on when you define the character.
The command your printer uses to define characters is one of the
most complex in its repertoire. The format of the command is this:
The ESC & is simple enough. The 0 (which is ASCII code 0, not the
numerical zero in quotation marks) allows for future enhancements.
At this time, it is always ASCII 0.
You can define many characters with a single command. The values
nl and n2 are the ASCII codes of the first and last characters you are
defining. If you are defining only one character, nl and n2 are the
same. You can use any codes between decimal 32 and 127 for n1 and
but it is best not to define decimal 32, which is the code for a
n2,
space. Also, you can use letters in quotation marks instead of ASCII
codes for and n2.
nl
An example will show how to specify nl and n2. For instance, if you
wanted to redefine the characters A through Z, nl would be A (or
ASCII code 65) and n2 would be Z (or ASCII code 90). So the
command ESC & 0 AZ (followed by the appropriate data) would
replace the entire alphabet of capital letters.
Software and Graphics
4-26
ESC & 0 nl n2 d0 dl d2 data