Opel MOKKA Owner's Manual page 271

11. Connect the compressor plug to
the 12 V power outlet or cigarette
lighter socket 3 63.
To avoid discharging the vehicle
battery, we recommend to use the
tyre repair kit only when the
combustion engine is running or
when the electric engine is ready.
12. Set the rocker switch on the
compressor to I. The tyre is filled
with sealant.
13. The compressor pressure gauge
briefly indicates up to
600 kPa (6 bar) whilst the sealant
bottle is emptying (approx.
30 seconds). Then the pressure
starts to drop.
14. All of the sealant is pumped into
the tyre. Then the tyre is being
inflated.
15. The prescribed tyre pressure
should be obtained within ten
minutes.
Tyre pressure 3 294.
When the correct pressure is
obtained, switch off the
compressor.
If the prescribed tyre pressure is
not obtained within ten minutes,
remove the tyre repair kit. Move
the vehicle one tyre rotation.
Reattach the tyre repair kit and
continue the filling procedure for
10 minutes. If the prescribed tyre
pressure is still not obtained, the
tyre is too badly damaged. Seek
the assistance of a workshop.
Vehicle care
Drain excess tyre pressure with
the button on the air hose.
Do not run the compressor longer
than ten minutes.
16. Detach the tyre repair kit. Remove
sealant bottle from compressor.
Screw the filler hose to the free
connection of the sealant bottle.
This prevents sealant from
escaping. Stow tyre repair kit in
load compartment.
17. Remove any excess sealant
using a cloth.
18. Continue driving immediately so
that sealant is evenly distributed
in the tyre. Drive between
20 km/h and 60 km/h. After driving
269