BEA WIZARD PLUS User Manual

The Wizard+ provides 3 functions in one package: Motion sensing, presence sensing, and imaging. The imaging
PRODUCT
function is an isolated function, and is not used for motion or presence detection. The camera provides an analog
DESCRIPTION
output for direct input to monitors, VCR's, etc.
COMPONENT ID
•
SAFETY
•
PRECAUTIONS
•
•
•
•
INSTALLATION
1.
2.
75.5043 V2 Jun 2003
TRI-FUNCTIONAL SENSOR
Part Number
10WIZARD+1
10WIZARD+1C
10WIZARD+2
10WIZARD+2C
Camera
Shut off all power going to the header before attempting any wiring procedures.
Maintain a clean & safe environment when working in public areas.
Constantly be aware of pedestrian traffic around the door area.
Always stop pedestrian traffic through the doorway when performing tests that may result in unexpected
reactions by the door.
Always check placement of all wiring before powering up to insure that moving door parts will not catch any
wires and cause damage to equipment.
Ensure compliance with all applicable safety standards (i.e. ANSI A156.10) upon completion of installation.
Remove the cover from the Wizard Plus. Take care when removing the cover, as it needs to be "rolled" off of
the base plate from the top down.
Rotate the cover off from the sensor so the cover may clear the camera lens.
When re-installing cover, simply reverse the procedure.
Remove the camera from the base plate as shown. Simply place a small screwdriver under the black housing of
the camera, and gently pry the camera from its mount plate. Once removed, unplug the 5-pin connector from
the sensor.
Gently pry camera
away from bracket
USERS GUIDE
WIZARD PLUS
Image Format
Black & White NTSC (USA)
Color NTSC (USA)
Black & White PAL (EUROPE)
Color PAL (EUROPE)
Extension Harness
With Female RCA Connector
60" Length
Non-removable connector at camera
5-pin connector with
red and black wire
Page 1 of 3