Replacing The Maintenance Tank - Epson Stylus Pro 4880 Quick Reference Manual

Replacing Printer Parts (continued)
Replacing Printer Parts (continued)
4
Hold down the side pin, as shown, then turn the
latch to the right.
5
Release the side pin and carefully remove the cutter
blade.
6
Insert the new cutter blade.
7
Hold down its side pin and secure it with
the latch.
8
Close the top cover. The carriage returns to the home
position and the cutter replacement is complete.

Replacing the Maintenance Tank

You need to replace the Maintenance Tank
(part # C12C890191) when you see MNT TNK FULL
on the LCD display. The ink light also turns red.
Note:
If you are using 220 ml ink cartridges, remove the
four cartrides from the right ink compartment, then close
the compartment cover.
1
Pull out the maintenance tank as shown.
Caution:
Do not tip the tank, or ink may spill out.
2
Place the used tank in the plastic bag included with
the new tank.
3
Insert the new tank.
Note:
If you removed any 220 ml ink cartridges,
replace them after inserting the new
maintenance tank.
7